Southbend X560DD S536A Manuel d'utilisateur télécharger pdf (Page 19)

500 SERIES RESTAURANT RANGES INSTALLATION

OWNER’S MANUAL 1188716 (09/07) PAGE 19 OF 48

STEP 3: ATTACH FLUE RISER AND SHELF ASSEMBLY

Place the flue riser assembly on the range as shown on the appropriate diagram below.

1. Slide the flue riser assembly over the bayonets until it bottoms out, as shown below.

2. Secure ends of flue riser assembly with two (2) 1/4-20 x 3/4 hex head bolts, flat washers and lockwashers

3. Attach the shelf assembly to the flue riser assembly.

Figure 7

Installation of Flue Riser and Shelf Assembly

Single-Oven Models Dual-Oven Models

STEP 4: ELECTRICAL CONNECTION (FOR CONVECTION-OVEN MODELS ONLY)

Wiring diagrams are located on the rear of the range. Be sure that the input voltage and phase match the

requirements shown on the serial plate (see

Figure 1 on page 3).

Ranges are factory-equipped either with a power cord or with one or two two-pole terminal blocks (one for each oven),

located behind cover plate(s) located on the rear of the range. To connect the supply wires, remove the appropriate

cover plate. Route the supply wires and the grounding wire through the strain relief fitting to the terminal block. Insert

the supply wires, one each, into the two poles of the terminal block and tighten the screws. Insert the ground wire into

the grounding lug and tighten the screw. Re-attach the cover plate.

Three phase ranges are wired as above, using only two supply wires. The third wire is not used and must be properly

terminated.

All ranges are shipped wired as specified by factory order. Conversion between single-phase and three-phase can be

accomplished by referring to phase loading and line amperes chart on wiring diagram for wire size and ampere

requirements.

STEP 5: GAS CONNECTION

If this equipment is being installed at over 610 meters altitude and that information was not specified when ordered,

contact the appropriate authorized Southbend Service Representative or the Southbend Service Department. Failure

to install with proper orifice sizing will result in poor performance and may void the warranty.

The serial plate is located on the interior side of the kick panel below the oven. It indicates the type of gas the range is

equipped to burn. All Southbend equipment is adjusted at the factory. Check type of gas on serial plate.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Pas de commentaire

Southbend X560DD S536A Manuel d'utilisateur Page 19