Southbend SEZ/3 Manuel d'utilisateur télécharger pdf (Page 10)

INSTALLATION SEZ SERIES COUNTERTOP STEAMERS

PAGE 10 OPERATOR’S MANUAL 1183437

INSTALLATION

Step 4: Water Connection

! WARNING

Do not connect steamer to a hot water line. A hot water connection will damage the steamer.

NOTICE

To meet warranty requirements, the supply water must meet the following specifications:

Pressure 30 to 60 PSI

Total Dissolved Solids (TDS) 60 PPM

Hardness 2 grains or 35 PPM

pH 7.0 to 7.5

Connect a cold water line to the water inlet strainer on the back of the steamer, as shown in Figure 4 on

page 9. The connector on the unit is 1/4" NPT male.

NOTE: To facilitate cleaning, and allow access to rear of unit, flexible connections are recommended. A shut

off valve at (or near) the rear of the unit is highly recommended. See Figure 5 below.

Figure 5

Check

Valve

Filter

Steamer

Cold

Water

Supply

Shut Off

Valve

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Pas de commentaire

Southbend SEZ/3 Manuel d'utilisateur Page 10