Southbend SB1269 Manuel d'utilisateur

MODEL SB1269 TAPER ATTACHMENT Instruction SheetThis taper attachment is heavy! Get assistance when installing this accessory on the lathe. Wear heavy

Operation6. Retighten both dovetail lock cap screws.7. Begin lathe operations.When the deadman clamp cap screws are loose, the deadman clamp slides

To disable the taper attachment:1. DISCONNECT LATHE FROM POWER!2. Use an 8mm hex wrench, and loosen both deadman clamp cap screws shown in Figure 2

3. Using an oil can with the same oil you use on your lathe ball oilers, apply oil on the knob threads shown in Figure 30.To clean the taper attachme

298733332313028121352212018171615141213121110343527263625222436231920511011484647334544434042403938372341464950Taper Attachment BreakdownFor Product M

REF PART # DESCRIPTION REF PART # DESCRIPTION2 PCAP02M CAP SCREW M6-1 X 20 28 PSB1269028 PIN3 PSB1269003 BALL OILER 30 PSB1269030 PIVOT SADDLE5 PSB126

WARRANTY & RETURNSThis quality product is warranted by South Bend Lathe Company to the original buyer for one year from the date of purchase. This

Copyright © February, 2010 By South Bend Lathe Co. Revised April, 2010 (CR).WARNING: No portion of this manual may be reproduced in any shape or form

IdentificationSerious personal injury could occur if you connect the lathe to power before completing the installation process. DO NOT connect power un

InventoryWhen you are completely satisfied with the condition of your shipment, you should inventory the contents.Inventory (Figure 3) QtyA. C

The unpainted surfaces are coated with a heavy-duty rust preventative that prevents corrosion during shipment and storage.This rust preventative has b

InstallationTo install the taper attachment:1. DISCONNECT LATHE FROM POWER!2. With the assistance of a helper and using a 6mm hex wrench, remove the

9. Lift out the slide block without losing the copper anti-score plug (Figure 8).12. Clean the bearings and races with mineral spirits, then dry and

Figure 15. Top plate installation.22. Reinstall the top plate as shown in Figure 15.17. Make sure the copper plug is still inside of the slide block

Figure 16. Deadman and arm installation.Deadman Clamp Cap ScrewDeadmanArmArmClevisArm ClampCap Screw29. Rotate, push in, or pull out the adjustment c

35. Loosen the four mounting cap screws and rotate the taper attachment left or right to correct the alignment (see Figure 21).Figure 22. Roll pin in